Tools Required To Unpack And Prepare The Router For Installation - Juniper MX2010 3D Quick Start Manual

Tools Required to Unpack and Prepare the Router for Installation

Copyright © 2014, Juniper Networks, Inc.
To unpack the router and prepare for installation, you need the following tools and
equipment:
Standard pallet jack—48 in. (121.92 cm) deep x 27 in (68.58 cm) wide.
Pallet jack attachment (model number MX2000-PLLT-JCK-ADPTR)
Router transport kit (model number MX2K-TRNSPRT-KIT)
Front component shipping cover
Rear component shipping cover
Phillips (+) screwdrivers, numbers 1, 2, and 3
1/2-in. (12.7 mm) drive ratchet
1/4-in. (6.35 mm) torque-controlled driver or socket wrench to tighten the nuts on the
router transport kit
1-1/8-in. (28.57 mm) torque-controlled driver or socket wrench to tighten router
transport kit winch mechanism
9/16-in. or 14-mm open-end or socket wrench with extension to remove bracket bolts
from the shipping pallet
Electrostatic discharge wrist strap
Antistatic mat
NOTE: We recommend that you install the MX2010 using a pallet jack with
attachment or a router transport kit.
Tools Required to Unpack and Prepare the Router for Installation
9