Juniper MX2010 3D Quick Start Manual page 18

MX2010 3D Universal Edge Router Quick Start
18
To remove the components from the router:
Slide each component out of the chassis evenly so that it does not become stuck or
1.
damaged.
Label each component as you remove it so you can reinstall it in the correct location.
2.
NOTE: The MX2010 PSMs can be installed in any order in the chassis.
Immediately store each removed component in an electrostatic bag.
3.
Do not stack removed components. Lay each one on a flat surface.
4.
To remove the upper and lower fan tray (see
Figure 12 on page 19):
NOTE: The fan trays are interchangeable and are hot-insertable and
hot-removable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the two captive screws on each side of the fan tray access panel and open.
2.
Loosen the two captive screws on the fan tray faceplate.
3.
Press and hold the latch while simultaneously pulling the fan tray out approximately
4.
1 to 3 in. Place one hand under the fan tray for support, while pulling the fan tray
completely out of the router.
NOTE: The double latch system is a safety mechanism, so you cannot
pull the fan tray out in one motion.
Place each component on an antistatic mat resting on a stable, flat surface.
5.
CAUTION: Do not stack fan trays on one another after you remove them.
Figure 11 on page 19 and
Copyright © 2014, Juniper Networks, Inc.