Safety Warnings - Juniper MX2010 3D Quick Start Manual

MX2010 3D Universal Edge Router Quick Start

Safety Warnings

66
WARNING: See installation instructions before connecting the router. This
is a summary of safety warnings. For a complete list of warnings for this
router, including translations, see the
Guide at http://www.juniper.net/techpubs/
WARNING: The intrabuilding port(s) of the router is suitable for connection
to intrabuilding or unexposed wiring or cabling only. The intrabuilding port(s)
of the router MUST NOT be metallically connected to interfaces that connect
to the OSP or its wiring. These interfaces are designed for use as intrabuilding
interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue
4) and require isolation from the exposed OSP cabling. The addition of primary
protectors is not sufficient protection to connect these interfaces metallically
to OSP wiring.
CAUTION: Before removing or installing components of a router, attach an
ESD strap to an ESD point and place the other end of the strap around your
bare wrist. Failure to use an ESD strap could result in damage to the router.
Only trained and qualified personnel should install or replace the router.
Perform only the procedures described in this Quick Start or in the
Edge Router Hardware Guide
personnel only.
Read the installation instructions before you connect the router to a power source.
Before installing the router, read the guidelines for site preparation in the
Universal Edge Router Hardware Guide
environmental, and clearance requirements for the router.
For the cooling system to function properly, the airflow around the chassis must be
unrestricted. Allow at least 36 in. (91.44 cm) of clearance between front to rear-cooled
routers. Allow 2.8 in. (7 cm) between the side of the chassis and any non-heat-producing
surface such as a wall.
Four people are required to move the MX2010 router.
Always remove the front and rear shipping covers before removing the components.
Always remove all components before moving the router. The empty router weighs
234 lb (106 kg).
When installing the router, do not use a ramp inclined more than 10 degrees.
Measure the shipping container to make sure there is adequate clearance through
doorways and passages to accommodate the dimensions.
MX2010 3D Universal Edge Router Hardware
.
. Other services should be performed by authorized service
to make sure that the site meets power,
Copyright © 2014, Juniper Networks, Inc.
MX2010 3D Universal
MX2010 3D