Table of Contents
Advertisement
MX2010 3D Universal Edge Router Quick Start
Step 2: Install the Mounting Hardware
Install the Mounting Hardware
10
Install the Mounting Hardware on page 10
A mounting shelf is required for installing the router in a four-post rack or cabinet. The
shelf is not required for installing the router in an open-frame rack.
Slide the large shelf between the rack rails, resting the bottom of the shelf on the rack
1.
supports. The large shelf installs on the rear rack rails, extending toward the front of
the rack, as specified in the
shelf installation. The distance between the front rack rail and rear rack rail is 36.20 in.
(91.95 cm).
Partially insert screws into the open holes in the rear flanges of the four-post mounting
2.
shelf (see
Figure 6 on page
NOTE:
Depending on the type of rack or cabinet you have, cage nuts may
be required.
Tighten all the screws completely.
3.
On the front of each front rack rails, partially insert a mounting screw into the holes
4.
in each ear of the four-post mounting shelf.
Tighten all the screws completely.
5.
NOTE:
The two rear flanges on the four-post mounting shelf are adjustable
from 24 in. (60.96 cm) to 30 in. (76.2 cm) to accommodate different types
of racks rails.
MX2010 3D Universal Edge Router Hardware Guide
11).
Copyright © 2014, Juniper Networks, Inc.
, for large
Advertisement
Table of Contents
