Juniper MX2010 3D Quick Start Manual page 22

Universal edge router

Table of Contents

MX2010 3D Universal Edge Router Quick Start

Using the pallet jack, lift the chassis approximately 0.75 in. above the surface of the

mounting shelf, and position it as close as possible to the shelf.

NOTE:

Due to the short lift capability of the pallet jack, it is recommended

to install the router on the bottom of the rack.

Remove the shipping brackets that are attached to the pallet jack attachment and

chassis.

Grasp the handles on the shipping covers and carefully slide the router into the rack

10.

(see and

Figure 15 on page 23

four-post rack, continue sliding the router onto the mounting shelf so that the bottom

of the chassis and the mounting shelf overlap by approximately 2 inches.

With four people pushing on the front-mounting flanges, slide the router until the

11.

center-mounting brackets (open-frame racks) or front-mounting flanges (four-post

racks) contact the rack rails. In a four-post rack, the mounting shelf ensures that the

holes in the front-mounting flanges of the chassis align with the holes in the rack rails.

Move the pallet jack away from the rack.

12.

Secure the router to the rack using the mounting screws provided by the rack

13.

manufacturer.

Visually inspect the alignment of the router. If the router is installed properly in the

14.

rack, all the mounting screws on one side of the rack should be aligned with the

mounting screws on the opposite side, and the router should be level.

and

Figure 16 on page

24). If installing the router into a

Table of Contents