Install The Router Using A Pallet Jack With Attachment; Install The Pallet Jack Attachment - Juniper MX2010 3D Quick Start Manual

Install the Router Using a Pallet Jack with Attachment

Copyright © 2014, Juniper Networks, Inc.
Figure 11: Removing Upper Fan Trays
WARNING: Before removing fan tray, make sure the fan blades have stopped
completely.
Figure 12: Removing Lower Fan Trays
NOTE: For complete instructions on removing router components, see the
MX2010 3D Universal Edge Router Hardware Guide
Install the Pallet Jack Attachment on page 19
Use the Pallet Jack with Attachment to Install the Router on page 20

Install the Pallet Jack Attachment

Remove the pallet jack attachment from the shipping crate.
1.
Place the pallet jack attachment across both pallet jack legs.
2.
Using a 9/16-in. (14 mm) drive socket wrench, loosen and remove the eight shipping
3.
bracket support torque fasteners that are located on the top of the pallet jack
attachment platform.
Install the Router Using a Pallet Jack with Attachment
.
19