Juniper MX2010 3D Quick Start Manual page 52

Universal edge router

Table of Contents

MX2010 3D Universal Edge Router Quick Start

Connect the wires to the AC terminal block on the three-phase wye AC PDM (see

10.

Figure 36 on page

53). Loosen the input terminal or grounding point screw, insert each

wire into the grounding point or input terminal, and tighten the screw (see

Table 5 on page 54

for approved AC wire gauge).

NOTE:

The terminal connections have either slotted screws or hex screws.

Use a 1/4-in. slotted screwdriver for the slotted screws. Use a 5/32-in.

(4-mm) Allen wrench for the 5/16-in. hex screws.

NOTE:

The three-phase wye AC PDM must be installed and secured in

the chassis before connecting the power input cables. If the PDM must

be removed, both input power cables must be uninstalled and removed

from the PDM before the PDM can be removed from the chassis. The

MX2010 chassis is not sensitive to phase rotation sequence—either CW

or CCW will operate correctly.

To connect wires to the terminal block that serves six PSMs:

a. Insert the grounding wire into the grounding point labeled

b. Insert the wire labeled

c. Insert the wire labeled

d. Insert the wire labeled

e. Insert the wire labeled

into the input terminal labeled

GND

Table of Contents