Install The Router By Using A Pallet Jack With Attachment; Install The Pallet Jack Attachment - Juniper MX2008 Quick Start Manual

MX2008 3D Universal Edge Router Quick Start

Install the Router by Using a Pallet Jack with Attachment

20
Figure 11: Removing Lower Fan Trays
WARNING: Before removing a fan tray, make sure that the fan blades have
stopped completely.
NOTE: For complete instructions on removing router components, see the
MX2008 3D Universal Edge Router Hardware Guide.
Install the Pallet Jack Attachment on page 20
Use the Pallet Jack with Attachment to Install the Router on page 21

Install the Pallet Jack Attachment

Remove the pallet jack attachment from the shipping crate.
1.
Place the pallet jack attachment across both pallet jack legs.
2.
Using a 9/16-in. (14 mm) socket wrench, loosen and remove the eight torque fasteners
3.
for bracket support that are located on the top of the pallet jack attachment platform.
Using a 9/16-in. (14 mm) socket wrench, loosen the torque fasteners that are located
4.
on the four adjustable pallet jack attachment brackets.
Adjust the four pallet jack attachment brackets until they fit under the pallet jack legs.
5.
Tighten the torque fasteners using a 9/16-in. (14 mm) socket wrench to secure the
6.
brackets on the pallet jack attachment to the pallet jack (see Figure 12 on page
Copyright © 2017, Juniper Networks, Inc.
21).