Table 3-7 Mgx 8850 Or Mgx 8850/B Required Tools And Equipment - Cisco MGX MGX 8800 Hardware Installation Manual

Site Requirements for the MGX 8850 or MGX 8850/B Switch
Table 3-7
Check
Cisco MGX 8800/8900 Series Hardware Installation Guide
3-26
MGX 8850 or MGX 8850/B Required Tools and Equipment
Tools and Equipment
Hardware Components and Cables
Cisco MGX 8850 or MGX 8850/B switches, with the front cards and back cards already
installed
If your configuration was not installed in a Cisco-supplied cabinet, you will need the
following components for your system:
Cabinet or rack that meets the RETMA Standard EIA-310-D requirements
•
Upper and lower fan trays
•
Air intake plenum
•
Exhaust plenum
•
AC power supply tray with power supplies—for AC-powered systems
•
DC PEM—for DC-powered systems
•
Blank front card faceplates, as needed:
• Single-height service module: Cisco Part Number SINGLE SM-CVR
SRM: Cisco Part Number SRM-CVR
•
Double-height service module: Cisco Part Number DOUBLE SM-CVR
•
PXM45 or PXM1E: Cisco Part Number PROCESSOR CVR
•
Back card blank faceplates, as needed:
For single-height back cards: Cisco Part Number 800-215911-00.
•
Blank faceplates and cover panels serve three important functions: they
Warning
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Mounting kit option for 23-inch rack: Cisco Part Number MGX-MNT23
Cable management assembly: Cisco Part Number MGX-CAB-MGMT
Switch earthing conductor—Minimum of 6 AWG stranded copper wire, rated at minimum
90°C
APS connector, as necessary—Cisco Part Number MGX-8850-APS-CON or
MGX-APS-CON
Fan tray power cable
DC PEM power cable—For DC-powered systems
AC power supply tray power cable—For AC-powered systems
Chapter 3
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Preparing for Installation