Vxsm T3 Interface - Cisco MGX MGX 8800 Hardware Installation Manual

Cisco systems switches installation guide
Hide thumbs Also See for Cisco MGX MGX 8800:
Table of Contents

Advertisement

Chapter 2
Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Note
For information on VXSM software features and configurations, refer to the Cisco Voice Switch Services
(VXSM) Configuration and Command Reference Guide for MGX Switches, Release 5. For technical
specifications for the VXSM cards, see the
page

VXSM T3 Interface

The VXSM T3 back card (part VXSM-BC-6-T3) supports up to 6 ports. The VXSM T3 back cards are
deployed in pairs; each supporting 3 T3 ports.
card interfaces.
Table 2-39
Parameter
Port speed
Maximum number of ports per back
card
Port media
Port connector
Line coding
Redundancy
For information on VXSM software features and configurations, refer to the Cisco Voice Switch Services
Note
(VXSM) Configuration and Command Reference Guide for MGX Switches, Release 5. For technical
specifications for the VXSM cards, see the
page
XM60
Supported models: MGX 8950
The XM60 is the switch fabric that powers the MGX 8950 switch. Up to four XM60s can be installed in
the MGX 8950 switch to provide 240 Gbps of switching capacity for the system. All four XM60s should
be installed to provide scalable bandwidth sharing and for full redundancy. (Operation with one or two
XM60 cards is not supported.)
The switch scheduling hardware optimizes switching throughput by adjusting to various traffic flows. A
single point of failure in the switch fabric does not block traffic flow in a system with multiple switch
modules. During normal operations, all installed XM60s can participate in cell switching to enable
maximum hardware usage and reliability.
The XM60s do not have corresponding back cards.
Note
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
A-2.
VXSM T3 Back Card Interfaces (Part VXSM-BC-3T3)
T3
44.736 Mbps
3
75-ohm coaxial cable
SMB
Binary 3-zero substitution (B3ZS)
1:1
A-2.
"Double-Height Service Module Specifications" section on
Table 2-39
provides information about the VXSM T3 back
"Double-Height Service Module Specifications" section on
Cisco MGX 8800/8900 Series Hardware Installation Guide
Front Cards
2-89

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8900 series

Table of Contents