Cisco MGX MGX 8800 Hardware Installation Manual page 444

Installing the MGX 8950 Switch
Figure 5-37
Figure 5-37
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
If a component requires more than two screws for installation in the rack or cabinet, install the two
Tip
bottom screws first.
Make sure that mounting the equipment does not create a hazardous condition due to uneven mechanical
Caution
loading. The equipment rack should be securely supported.
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
—This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
—When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-60
shows a front view of the mounting rails.
Rack Mounting Dimensions—Front View
17.750"
Minimum
between rails
MGX 8950
Chapter 5 Installing the Cisco MGX Switch or Gateway
22.750"
13 RMUs
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006