Cisco MGX MGX 8800 Hardware Installation Manual page 472

Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Figure 5-53 Power Interconnect Connections for DC
DC power
interconnect
cables
Connect the Back Cards
Connect the interfaces from the back cards to the appropriate end device. See Appendix B, "Cable
Specifications" for cabling specifications and pinouts.
Once you have connected your back cards, route the cables through the cable management assembly. The
upper card set cables run to the upper cable management panel, and the lower card set cables run to the
bottom cable management panel. Figure 5-54 shows cables routed through the upper cable
management panel.
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-88
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006