Module Configurations; Cisco Mgx 8800/8900 Series Hardware Installation Guide; Table 2-9 Ausm Leds - Cisco MGX MGX 8800 Hardware Installation Manual

Front Cards
Table 2-9
Table 2-9
LED
ACT
STBY
FAIL
PORT 1 through
PORT 8

Module Configurations

The AUSM supports the following module configurations:
•
•
•
•
•
For module configuration information, see
Note
Redundancy, and Bulk

Cisco MGX 8800/8900 Series Hardware Installation Guide

2-12
describes the LEDs on the AUSM cards.
AUSM LEDs
Status
Green
Yellow or
blinking yellow
Red
Green
Red
Yellow
Off
Standalone.
1:N card set redundancy, without bulk distribution.
1:N card set redundancy, with bulk distribution—For line redundancy to be supported in this
configuration, there must be redundant PXM1Es and redundant SRME cards. The APS connector
must be installed between the SRME cards.
Bulk distribution.
IMA (ATM Forum 1.0-compliant only).
Distribution".
Chapter 2 Illustrated Card List for MGX Switches and the MGX 8880 Media Gateway
Description
The AUSM card set (front card and back card) is in active
state.
One of the following conditions exists:
The AUSM is in Standby mode.
•
• The AUSM is in mismatch state.
• The AUSM digital signal processors (DSPs) are
currently involved in the AUSM bootup process.
When this LED is solid red and the ACT and STBY LEDs
are off, one of the following conditions exists:
The module is in Reset mode.
•
The module has failed.
•
The card set is not complete (no back card).
•
The port is active with no alarms detected.
The port is active and a local alarm has been detected.
The port is active and a remote alarm has been detected.
The port is not configured, or the card set is configured as
a redundant card set and is in Standby mode.
Chapter 4, "Planning for Card Redundancy, Line
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006