Cisco MGX MGX 8800 Hardware Installation Manual page 331

Chapter 3 Preparing for Installation
Table 3-13
Front Card
•
•
•
XM60
Fan tray (for each)
Note
DC PEM
Totals
Required Tools and Equipment
Table 3-14
components.
For additional cabling requirements, see
Note
Table 3-14
Check
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Power Consumption Calculation for MGX 8950 Switch Components (continued)
MGX-1GE
MGX-2OC12POS-IR
MGX-2GE
Two fan trays are
needed at all times
for the MGX 8950.
lists the tools and equipment that you need to install and remove MGX 8950 switch
MGX 8950 Required Tools and Equipment
Tools and Equipment
Hardware Components and Cables
MGX 8950 switch, with the front cards and back cards already installed
If your configuration was not installed in a Cisco-supplied cabinet, you will need the
following components for your system:
Cabinet or rack that meets the RETMA Standard EIA-310-D requirements
•
Upper and lower fan trays
•
Air intake plenum
•
Exhaust plenum
•
AC power supply tray with power supplies—for AC-powered systems
•
DC PEM—for DC-powered systems
•
A B
Number of Cards Watts Per Card
Installed
11
15
13
55.3
75.6
20
Appendix B, "Cable Specifications."
Cisco MGX 8800/8900 Series Hardware Installation Guide
Site Requirements for the MGX 8950 Switch
C D
Total Card Total 48V Current
Power (ADC)
(AxB) (C/48)
3-39