SCSI Cable and Guidelines
All workstation models use three areas for connecting mass storage SCSI
devices: internally with hard drives in the removable hard drive cage, internally
with storage devices in the front panel drive bays, and externally with external
storage devices. The workstation has an integrated Wide-Ultra SCSI controller
that has one internal connector on the system board and one external connector
on the rear panel.
SCSI Cables
The workstation ships standard with a 5-device Wide-Ultra SCSI cable
has a terminator on one end. One end of this cable connects to the internal
Wide-Ultra SCSI connector on the system board, and the other end (first device
connector) of the cable connects to the hard drive in the removable hard drive
cage. The cable has five connectors to handle up to five SCSI devices, a
maximum of three in the removable hard drive cage and two in the front drive
bay area.
1
Figure 8-18. 5-device Wide-Ultra SCSI cable
NOTE: The SCSI cable included with your workstation may look slightly
different than the one pictured.
When installing a Wide-Ultra2 SCSI hard drive, a Wide-Ultra2 SCSI cable is
required (not shown).
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP500 Reference Guide
8-15
that