Installing A 7200 Rpm Hard Drive In Bays 5 Or 6 - Compaq Deskpro AP500 Reference Manual
Hp deskpro ap500: reference guide
Hide thumbs
Also See for Deskpro AP500:
- Maintenance and service manual (9 pages) ,
- Supplementary manual (21 pages)
Table of Contents
Advertisement
8-6
Drives
Installing a 7200 rpm Hard Drive in
Bays 5 or 6
Drive bays 5 and 6 can be configured with either 1.0-inch or 1.6-inch, 7200 rpm
hard drive. Other than using different screw holes, the installation for both
drives is basically the same.
NOTE: Before installing a SCSI device, please read "SCSI Cables and
Guidelines" later in this chapter.
To install a 7200 rpm hard drive:
1.
Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2.
Remove the following components:
3.
Refer to the following illustrations to install a 7200 rpm hard drive in
bays 5 or 6.
Figure 8-5. Installing a 7200 rpm hard drive in the hard drive bracket
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
side access panel
front bezel
cooling shield
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Advertisement
Table of Contents
Troubleshooting
