Removing The Subpanel And Bezel Blank - Compaq Deskpro Workstation AP250 Maintenance And Service Manual

3-6 Compaq Deskpro Workstation AP250 Maintenance and Service Guide

Removing the Subpanel and Bezel Blank

Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
1. Turn off the workstation and any external devices. Disconnect the power
cord from the grounded AC outlet and the network cable from the
system.
2. Loosen the two thumbscrews that secure the side access panel to the
workstation chassis.
3. Remove the workstation side access panel.
4. Remove the front bezel.
5. Gently pull the subpanel, with the bezel blank secured in it, away from
the front bezel. Remove the bezel blank.
CAUTION: Hold the subpanel straight when you pull it away from the front
bezel. Pulling the subpanel away at an angle could damage the pins that align it
within the front bezel.
Figure 3-5. Removing the subpanel and bezel blanks
To replace the subpanel and bezel blank, reverse the above procedure. Be sure
the subpanel and front bezel align properly with the alignment tabs.
Compaq Confidential – Need to Know Required