Removing A Cooling Shield - Compaq Deskpro AP500 Reference Manual
Hp deskpro ap500: reference guide
Hide thumbs
Also See for Deskpro AP500:
- Maintenance and service manual (9 pages) ,
- Supplementary manual (21 pages)
Table of Contents
Advertisement
8-4
Drives
Removing a Cooling Shield
A cooling shield covers bays 5 and 6 to provide proper cooling and EMI
protection.
To remove a cooling shield:
1.
Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2.
Remove the side access panel and front bezel.
3.
Refer to the following illustration to remove a cooling shield.
Figure 8-3. Removing a cooling shield
IMPORTANT: You will also need to replace the shield after the drive is
installed in the bay.
To replace the cooling shield, reinsert the two screws.
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
T
COM PAC
Advertisement
Table of Contents
Troubleshooting
