Scsi Guidelines For Installing Scsi Devices - Compaq Deskpro AP500 Reference Manual

8-16 Drives

SCSI Guidelines for Installing SCSI Devices

If you are installing a narrow SCSI device, you will need to attach a
68- to 50-pin SCSI adapter to the narrow SCSI device.
A maximum of seven SCSI devices may be installed on the integrated
Wide-Ultra SCSI controller.
A unique SCSI ID (0-6 and 8-15) must be set for each SCSI device
installed.
Before you install a SCSI device, verify the SCSI ID of the drive and, if
necessary, set the SCSI ID to a unique ID number.
The controller identifies a SCSI device by its SCSI ID (SCSI ID 1)
number rather than its bay location (bay 2). Therefore, moving a SCSI
device from one bay location to another or changing the position of the
device on the SCSI chain does not affect the communication between
the controller and the SCSI device.
The reserved and available SCSI ID numbers for SCSI devices are as
follows:
Bay 4 is reserved for the CD-ROM drive. Do not install a SCSI device
in the bay.
If only one SCSI hard drive is used, install it in the lowest numbered bay
(bay 1).
Every SCSI chain must be terminated (closed) at both ends.
SCSI devices may not have terminating jumpers on the device.
Determine if the device ought to have termination enabled or disabled.
Set the termination if necessary. Termination on these devices must be
achieved with a terminated cable.
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
SCSI ID 0 is reserved for the primary hard drive (bootable drive).
SCSI ID 7 is reserved for the controller.
SCSI IDs 1-6 and 8-15 are available. 8-15 should not be used with
narrow devices on the same SCSI bus.
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED