Reconfiguring The Workstation - Compaq Deskpro AP500 Reference Manual

6. Reconnect the power cord to the back of the workstation and plug in the
power cord to a grounded AC outlet.
7. Turn on the monitor, workstation, and any devices you installed.
8. Reconfigure the workstation, if necessary. See Chapter 2 for instructions.
9. Test the workstation (optional) using the TEST utility.

Reconfiguring the Workstation

System configuration is the process of specifying the devices and programs that
make up a system. When you add or remove optional equipment, you must
reconfigure the workstation by running Computer Setup in order for the
changes to be recognized.
Run the Computer Setup utility after you complete the installation. To
configure in Windows NT, use Control Panel and configure your specific
option.
If configuration settings are incorrect, one or more devices may not work
properly, and you may receive an error message. If this occurs, run the
Computer Setup utility again. See Chapter 2 for more information on Computer
Setup.
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: G-CH06.DOC Last Saved On: 2/11/99 8:24 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP500 Reference Guide
6-3