Suzuki LT-Z90 Manual page 84

3-36 ENGINE
INSPECTION
• Install the starter clutch in the proper direction as shown.
NOTE:
When installing the starter clutch onto the rotor, make sure that
the arrow mark A in the bearing faces to the rotor.
• Apply engine oil to the starter clutch.
• Apply a small quantity of THREAD LOCK SUPER "1322" to
the starter clutch bolt.
99000-32080: THREAD LOCK SUPER "1322"
• Tighten the bolts while holding the rotor with the special tool.
Starter clutch bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
09930-44520: Rotor holder
STARTER DRIVEN GEAR BEARING INSPECTION
Inspect the starter driven gear bearing for any wear or damage.
If any defects are found, replace the stater driven gear bearing
with a new one.
STARTER DRIVEN GEAR BEARING DISASSEMBLY
• Remove the bearing with the special tool.
09930-31920: Roter remover
09924-84521: Bearing installer
(or equivalent thread lock)