Suzuki LT-Z90 Manual page 103

DRIVE BELT INSPECTION
Inspect that the drive belt is free from any greasy substance.
Inspect the contact surface of the drive belt for cracks or dam-
age and measure the width of the drive belt with a vernier cali-
pers.
If any defects are found or the measurement exceeds the ser-
vice limit, replace the drive belt with a new one.
If grease or oil is present on the surface of the drive
belt, degrease the belt thoroughly.
Drive belt width:
Service Limit: 18.9 mm (0.74 in)
MOVABLE AND FIXED DRIVEN FACE INSPECTION
Inspect the driven face for any abnormal condition such as
stepped wear or discoloration caused by burning.
If any damages are found, replace the then with new ones.
CLUTCH SHOE/MOVABLE DRIVEN FACE DIASSEMBLY
INSTALLATION
• Install the new O-rings 1 .
• Apply SUZUKI SUPER GREASE "A" to the oil seal lips and
movable driven face inside grease groove.
99000-25030: SUZUKI SUPER GREASE "A"
The removed O-rings must be replaced with a new
one.
(or equivalent)
ENGINE 3-55