Suzuki LT-Z90 Manual page 165

• Tighten the tie rod end nut to the specified torque and install
the cotter pin.
Tie rod end nut: 50 N·m (5.0 kgf·m, 36.0 Ib-ft)
NOTE:
Make sure that the steering turns smoothly in both directions.
The removed cotter pin must be replaced with a new
one.
• Install the front brake. (
• Install the front grip. (
• Install the front wheel. (
After installing the front brake and front suspension, adjust the
following items.
* Front brake lever play. (
STEERING
• Remove the front fender. (
• Remove the front suspension. (
• Remove the steering head cover 1 .
• Remove the right grip 2 , front brake lever 3 .
• Remove the left grip 4 , left handle switch 5 and rear brake
lever 6 .
• Disconnect the left handle switch coupler 7 and parking
brake switch coupler 8 .
5-16)
5-7)
5-9)
2-20)
5-5)
5-22)
CHASSIS 5-25