3-52
ENGINE
DAMPER INSPECTION
Inspect the dampers for wear or damage.
If any defects are found, replace the dampers with new ones.
MOVABLE DRIVE FACE INSTALLATION
• Mount the dampers 1 on the movable drive face plate 2 .
• Position the rollers 3 on the movable drive face 4 .
• Check that the rollers 1 are in normal position in the movable
drive face 2 .
• Position the movable drive face plate 2 on the movable drive
face 2 .
CLUTCH SHOE/MOVABLE DRIVEN FACE DISASSEMBLY
• Hold the clutch shoe assembly 1 with the special tool.
09930-40113: Rotor holder
• Loosen the clutch shoe nut 2 .
Do not remove the clutch shoe nut before attaching
the clutch spring compressor.
• Attach the special tool to the clutch shoe/movable driven face
assembly and compress the clutch shoe assembly by turning
in the special tool handle 3 .
09922-31420: Clutch spring compressor
• Remove the clutch shoe nut 4 .
Since a high spring force applies to the clutch shoe
assembly, care must be used so as not to cause the
clutch shoe assembly and movable driven face to
come off abruptly.