Suzuki LT-Z90 Manual page 32

2-16 PERIODIC MAINTENANCE
• Remove the limit clutch friction plate E and limit clutch F .
• Remove the movable driven face G and drive belt H .
INSPECTION
Inspect the drive belt for wear and damage. If any defects are
found, replace it with a new one.
INSTALLATION
Install the drive belt in the reverse order of removal. Pay atten-
tion to the following points:
• Insert the drive belt, as low as possible, between the movable
driven face to provide the maximum drive belt clearance
before installing.
• Install the movable driven face with drive belt.
* Fit the drive belt to the movable driven face so that
the arrows on the drive belt outer surface aim toward
normal turning direction.
* The drive belt contact surface of the driven face
should be thoroughly cleaned.