Generator - Suzuki LT-Z90 Manual

STARTER DRIVEN GEAR BEARING INSTALLATION
• Install the bearing with the special tool.
09913-70210: Bearing installer set ( 30)
The removed bearing must be replaced with a new
one.
NOTE:
The stamped mark on the bearing must face crankcase side.

GENERATOR

INSPECTION ( 6-9)
DISASSEMBLY
• Remove the generator coil 1 , CKP sensor 2 , grommet 3 .
REASSEMBLY
• When replacing the generator coil or CKP sensor, route the
wire properly.
• Apply a small quantity of THREAD LOCK SUPER "1322" to
the CKP sensor mounting bolts 1 and tighten them securely.
99000-32080: THREAD LOCK SUPER "1322"
CKP sensor mounting bolts: 6 N·m (0.6 kgf-m, 4.5 lb-ft)
• Apply a small quantity of THREAD LOCK SUPER "1322" to
the generator coil mounting bolts 2 , and tighten them
securely.
99000-32080: THREAD LOCK SUPER "1322"
Generator coil mounting bolts:
(or equivalent thread lock)
(or equivalent thread lock)
10 N·m (1.0 kgf-m, 7.0 lb-ft)
ENGINE 3-37