During Copying - Gestetner CS331 Copying Manual

During Copying

You can preset the next copy modes during a copy run.
You cannot preset the next copy modes during the scanning of the originals.
1 Place the original(s).
2
Press the JOB PRESET key during a copy run.
- The following message appears:
JOB PRESETTING
Select other copy modes as required.
3 Press the START key.
4
The preset job will start when the current copying is
finished.
If the copy run is interrupted due to running out of paper, etc.
during job presetting, press the JOB PRESET key to set the
desired copy modes again after the copy operation restarts.
Canceling Preset Job during Copying
To cancel the preset copy job, press the JOB CANCEL key.
Page 2-9
1
2
3
4
5
6
7
8
9
10
11
12
2-15