Bypass Copying On Standard Size Or Full Bleed Paper - Gestetner CS331 Copying Manual

Bypass Copying on Standard Size or Full Bleed Paper

1 Perform steps 1 to 2 on page 6-6.
Set the "OTHER" size key as necessary.
If the paper that has been set is the standard size other than
LD, LG, LT or ST, you will select the OTHER key in step 4. In
this case, you need to make the OTHER key recognize the
same size as the paper that has been set. Such setting should
be done at this step.
2
Press the PROGRAM
menu, and press the BYPASS FEED key.
- When paper is set on the sheet bypass, pressing the bypass
guide icon as shown on the right-hand display can also
make the screen in step 3 appear.
3
After selecting the paper type key corresponding to
the type of the paper that has been set, press the
SET key.
- Plain paper is selected as the default mode (half-tone
shaded).
- When using Full Bleed paper, press both the paper weight
key and the 12" x 18" key. Then press the SET key.
Page 6-16
key to enter the program
1
2
3
4
5
6
7
8
9
10
11
12
6-7