Table of Contents
Advertisement
Display settings, switchoff and additional options
• Click on 'Display' in the 'Device Setup' screen.
Brightness: Press the navigation key right or left until the desired
brightness is achieved. To accept the setting, press 'Enter'.
Switch backlight off / Auto power off: The display/ the device
automatically switches off if no action occurs within the turn-off
time (illumination: 10s ... 1m / device: 6m ... 6h). To switch on
the display, press any key. The automatic switch off is disabled
in the measurement screen / results screen.
Show battery charge: Display the residual battery charge in percent.
Spectrum: Show lines below lower frequency (f
a lower limit frequency of f
f
are displayed in the diagram if this option is enabled.
min.
Hide calibration hint: The message for overdue calibration is not
shown.
• To accept the settings, press MENU and click on 'OK'.
Protective display film
To protect the display against damage, it is covered with a scratch-
proof transparent film. The film is easy to remove.
): In spectra with
min
> 0 Hz, the lines between 0 Hz and
min.
Getting started - Basic settings
Note
Display settings
2-13
Advertisement
Table of Contents
