Table of Contents
Advertisement
• Installation:
Insert the new card in the guide rails of the card slot. Carefully
press in the card up to the endstop. Make sure the card is
correctly oriented! The top of the card should face the back of the
device.
• Coat the groove along the edge of the card compartment cover
with a small amount of silicone adhesive (NOVASIL S-11) and
replace the cover. Remove any excess adhesive with a cloth.
Notch for silicone adhesive (framed)
The cover can also be replaced without silicone adhesive. The de-
vice complies with protection class IP 55 then.
When the device is switched on, the card is automatically tested.
The following scenarios are possible:
Card formatted, which version?
- The card is new and has not yet been formatted in a VIBXPERT:
you are prompted to format the card.
- The card has already been used in another VIBXPERT:
Card version < firmware version in the device: the files on the
card are automatically updated.
Card version > firmware version in the device: you are prompted
to reset all settings to the "factory settings" ('Reset', P. 2-29).
Card version = latest firmware version: no action.
Card faulty?
- The file system on the card is damaged. A warning appears
along with the instruction to have the card repaired. If possible,
make a backup copy of the measurement data (see 'Backup', page
6-8).
Start card formatting and repair in the 'Service' menu (P. 2-29).
How much free memory capacity is there?
The free memory capacity is checked regularly during operation. A
message appears when the memory is almost full.
Getting started - Memory card
Note
2-11
Advertisement
Table of Contents
