Table of Contents
Advertisement
4-20
Display setup
Phase vector as a function
of the rpm (see figure) or the time
2-channel display setup for
1+1 measurement
C2. Display setup for trend: phase
Phase over...: When several phase measurements are saved in one
file, the phase vectors can be shown depending on the time or
rpm (see below).
Phase trend diagram
Use the F-key to open a menu in the results screen (see below) with
the following options:
Details:
Nyquist / Bode:
Show channel:
D. Display setup for measurement: 2-channel measurement (1+1)
Spectrum display:
measurement, you can choose whether only the spectrum,
or also the set additional info (max. 10, time waveform,.. see
section B1) should be displayed.
Display setup channel A / B: Click on Show to display the display
settings of the individual measurement tasks.
To edit the display settings of the individual measurement tasks,
enable the required window pane in the result screen and call
up the display setup via the MENU key (see diagram on page
5-24).
E. Display setup for measurement: impact test
Bump display: Choose whether the result of the impact test should
be displayed as a time waveform or spectrum.
Select result after save: The result selection dialog window opens
automatically (yes) after a measurement is stored.
Left:
Phase trend
Right:
Impact test
Show result of a single measurement
Change diagram type
Show channel A, channel B or both channels.
If the measurement task contains a spectrum
Advertisement
Table of Contents
