Table of Contents
Advertisement
2-16
Getting started - Basic settings
Basic settings for the route/
template operating mode
Setting up the measurement
Measurement settings
• Click on 'Measurement' to set up the following options:
Autostart measurement
This shortens the duration of the entire measurement.
- Enabled: Clicking the measurement location starts the first
measurement automatically. If multiple measurement tasks are
defined for the same accelerometer at a single measurement
location, these measurement tasks are automatically run
consecutively, provided that the 'Auto Save' option is enabled
(see next section).
- Disabled: The first measurement at a measurement location must
be started manually.
Autostart MUX
This options shortens the time between the measurements.
- Activated: The measurements start automatically as soon as a
multiplexer measurement location is opened in the selection
screen.
- Deactivated: The measurements have to be started with 'Enter'.
Route optimizer
This function optimizes the processing of the route and shortens the
time involved in collecting the measurement data.
- Enabled: Measurement tasks for a measurement location with the
same sensor are processed one after the other.
- Disabled: Measurement tasks are processed in the sequence in
which they were created in OMNITREND.
Optimize meas. time for MultiTask
The individual measurements are performed with a sensor but are
processed in parallel on 2 channels in VIBXPERT.
- Enabled: Measurements are internally distributed to both
measurement channels and are processed in parallel.
- Disabled: Measurements are performed in sequence on one
channel.
Left:
Right:
Advertisement
Table of Contents
