Skoda Citigo 2012 Workshop Manual page 63

5 - Adapter for the installed expansion valve
❑ Different versions depending on the vehicle.
❑ From the adapter case of the motor car set -VAS 6338/1- .
6 - Evaporator
7 - Connection to the fluid reservoir
❑ Different versions depending on the vehicle.
❑ Not available on vehicles with a dessicator cartridge in the fluid reservoir at the condenser or with a fluid
reservoir installed in the condenser.
8 - Adapter for bridging the removed fluid reservoir
❑ Not required on all vehicles (see the above-mentioned point).
❑ Different versions depending on the vehicle.
❑ From the adapter case of the motor car set -VAS 6338/1- .
9 - Filling hose for refrigerant
❑ From the adapter case of the motor car set -VAS 6338/1- .
10 - Condenser
❑ If a fluid reservoir with dessicator cartridge is installed at the condenser, the dessicator cartridge must
be removed (close again after removing fluid reservoir at or in the condenser).
11 - Connection of the high-pressure side on the refrigerant circuit to the A/C compressor
❑ Different versions depending on the vehicle.
12 - Adapter to connection for the high-pressure side of the refrigerant circuit
❑ Different versions depending on the vehicle.
❑ From the adapter case of the motor car set -VAS 6338/1- .
13 - Filling hose of flushing device for the refrigerant circuits
❑ From connection to high-pressure side of the A/C compressor in the refrigerant circuit (smaller diameter)
to inlet of flushing device for the refrigerant circuits.
14 - Flushing device for the refrigerant circuits
❑ E.g -VAS 6456A- or -VAS 6338A- (different versions and different structures).
❑ With filter, inspection glass, safety valve, heating, refrigerant reservoir etc. (depending on the version).
❑ Depending on the structure of the A/C service station and the flushing device for the refrigerant circuits,
a non-return valve can be installed on the outlet of the flushing device for the refrigerant circuits (in order
to ensure the correct flow direction of the refrigerant when flushing).
15 - Refrigerant hoses on the A/C service station
❑ From the low-pressure side of the A/C service station (usually blue in colour) to the outlet of the flushing
device for the refrigerant circuits.
Refrigerant circuit with throttle and catch pan
Note
The throttle is removed and the refrigerant pipes are assembled again. The catch pan is also removed and the
line connections to the reservoir are connected together again. To do so, use the adapter and the filling hose
from the adapter case of the motor car set -VAS6338/31- , see
⇒ "7.4 Adapter for setting up the rinsing cycles", page 61
Citigo 2012 ➤ , Fabia 2000 ➤ , Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fab ...
Air conditioning system with refrigerant R134a - Edition 10.2014
.
7. Removing contaminants from the refrigerant circuit
59