Skoda Citigo 2012 Workshop Manual page 203

1 - Blower regulator
2 - Display of ambient temper‐
ature
❑ If the driving speed
drops below 15 km/h
and if the refrigerant
temperature is above
70°C, the displayed val‐
ue will not change. Thus
the actually measured
ambient temperature is
not displayed as it could
be negatively influenced
at low speed by the stor‐
ed heat of the engine.
3 - Display for blower stage
4 - Display for connected vehi‐
cle diagnosis, measurement
and information system ⇒ Ve‐
hicle diagnostic tester
5 - Display for defrosting the
windscreen
6 - Display for re-circulating air
operation
7 - Display for air flow direction
8 - Display of the selected in‐
terior temperature
9 - Rotary knob for interior tem‐
perature
10 - Button for fresh air/re-cir‐
culating air mode
11 - Display for operating con‐
dition
12 - Button
ECON
❑ By pressing the button
ventilation operation continues to be controlled electronically.
13 - Button for air flow in the head area
14 - Button for upper body air flow
15 - Button for air flow in the foot area
16 - Button
AUTO
❑ By pressing the button
fully automatically. To this end the temperature of the expelled air, the blower speed and the air distri‐
bution are automatically changed.
17 - Dash panel temperature sensor - G56- and Temperature sensor blower - V42-
Note
In the event of a failure to the tem‐
perature sender for dash panel -
G56- or the temperature sender
blower - V42- replace the control
and display unit for air conditioner,
Climatronic - E87- .
18 - Button for defrosting the windscreen
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
the AC compressor is adjusted close to zero output. The heating and
ECON
the Climatronic maintains the selected interior temperature for the vehicle
AUTO
Heating, Air conditioning - Edition 06.2013
11. Climatronic - Air conditioner with automatic regulation)
93