Components Of The Air Conditioning System In The Engine Compartment - Summary Of Components- Vehicles From My 2011 - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
5.2 Components of the air conditioning system in the engine compartment -
Summary of components- vehicles from MY 2011
1 - Bolts
❑ 2 Nm
2 - Holder for refrigerant lines
❑ Properly secure the re‐
frigerant lines
3 - Nuts
❑ 20 Nm
4 - Holder for refrigerant lines
❑ Properly secure the re‐
frigerant lines
5 - High-pressure sender -
G65-
❑ function ⇒ page 32
❑ remove and install, test
⇒ page 49
6 - Exhaust valve*
❑ Low-pressure side (ca‐
ble with larger diameter)
❑ for exhaust and meas‐
urement only
❑ removing and installing
⇒ page 30
❑ 9 Nm
7 - Expansion valve*
❑ Removing and installing
the refrigerant lines
⇒ page 46
❑ removing and installing
⇒ page 50
8 - Valve for condensation wa‐
ter drain*
❑ behind heat-protection matting of the front wall (assembly plate)
❑ Fit only on removed heating and air conditioning unit
❑ check ⇒ page 47
9 - Ambient temperature sensor - G17-
❑ removing and installing
10 - Fluid container with dessicator cartridge*
❑ the container is a component part of the condenser
❑ If the refrigerant circuit was separated, it is not always necessary to replace the dessicator, see ⇒ Air
conditioning system with refrigerant R134a; Rep. gr. 00 Chapter "Replacing components of the refrig‐
erant circuit".
❑ Remove and install dessicator cartridge
11 - Condenser*
❑ Removing and installing the condenser
❑ Removing and installing the refrigerant lines
12 - Pressure relief valve*
❑ O-Ring: 8.6 mm; 1.8 mm
❑ Tightening torque: 10 Nm
42
⇒ page 48
⇒ page 55
⇒ page 54
⇒ page 43