Removing And Installing The Condenser - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
♦ If pressure and temperature measurements indicate that there
is humidity in the refrigerant circuit
♦ There is a doubt about the oil volume in the refrigerant circuit
♦ The air conditioning compressor needed to be replaced be‐
cause of internal damage (e.g. noise or no output)
♦ Required for the respective vehicle after replacing one of the
components of the workshop manual
6.7

Removing and installing the condenser

Note
Repairs must only be carried out in specialist service centres
♦
which have suitably trained personnel and are fitted out for
working on the refrigerant circuit.
If the refrigerant circuit was separated, it is not always neces‐
♦
sary to replace the dessicator, see ⇒ Air conditioning system
with refrigerant R134a; Rep. gr. 00 Chapter "Replacing com‐
ponents of the refrigerant circuit".
⇒ "6.7.1 Vehicles up to MY 2010", page 54
⇒ "6.7.2 Vehicles as MY 2011", page 54
6.7.1 Vehicles up to MY 2010
Removing
– Drain the refrigerant circuit with the aid of the A/C service sta‐
tion.
– Removing the lock carrier ⇒ Body Work; Rep. gr. 50 .
– Remove the refrigerant lines from the condenser
– Release screws -3- (5 Nm).
– Remove condenser -4- from the radiator -1-.
– The sealing tape -2- is not fitted as of CW 13.2010.
Install
Installation is carried out in the reverse order. Pay attention to the
following:
– Fill the refrigerant circuit with the aid of the A/C service station.
6.7.2 Vehicles as MY 2011
Removing
– Drain the refrigerant circuit with the aid of the A/C service sta‐
tion.
– Removing the lock carrier ⇒ Body Work; Rep. gr. 50 .
– Remove the refrigerant lines from the condenser
54
⇒ page 43 .
⇒ page 43 .