Skoda Citigo 2012 Workshop Manual page 210

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
– Put gear wheels of control motors -1- and -2- in the position
shown in the fig.
– Set gear wheels -1- and -2- by applying battery voltage to plug
-3- and -4- with adapter cables from the measuring tool set
V.A.G - 1594 A- to contacts -5- and -6- of the control motor
plug; the running direction is altered by changing the cable
from positive to negative.
– Position lever -1- of defroster flap and -2- of temperature flap
in the shown position.
Note
Pay attention to short tooth and thus to a larger gap between the
teeth at this point on both levers.
– Put holder of control motors into the brackets -5-.
– Guide defroster flap control motor -V107- -2- with lever -1- and
temperature flap control motor -V68- -4- with lever -3- to each
other, pay attention to the correct position of the gear wheels
to the levers.
Note
If the gear wheel and the lever are not aligned as mentioned, the
control motor is blocked as soon as the large tooth cannot grip
into the wide gap between the teeth.
100