Dash Panel Vent And Air Guide Ducts, Ventilation; Removing And Installing The Centre Dash Panel Vent - Skoda Citigo 2012 Workshop Manual

2 Dash panel vent and air guide ducts,
ventilation
⇒ "2.1 Removing and installing the centre dash panel vent", page
7
⇒ "2.2 Removing and installing the right/left side vent",
page 8
⇒ "2.3 Remove and install footwell vent", page 8
⇒ "2.4 Remove and install the Forced ventilation frame for pas‐
senger compartment, check", page 9
2.1 Removing and installing the centre dash
panel vent
Special tools and workshop equipment required
♦ Release tool - T30111-
Removing
– Switch off the ignition and all electrical components.
– Consecutively insert the release tool -2- into the recesses
-arrow A- in the catch pegs -3- and unlock the catch peg by
swiveling out the release tool -arrow B-.
– Lock the catch peg by sliding the release tool -arrow C- into
the opening of the catch peg -arrow D-.
– Pull out the vent after inserting the eight release tools.
Note
Take out the release tools immediately after removing the vent so
that the catch pegs are not under any unnecessary stress.
– Disconnect plug.
Install
– Mount plug.
– Press the vent at the concealed frame into the installation
frame in the dash panel, until the catch pegs click audibly into
place.
– Perform a functional test.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013

2. Dash panel vent and air guide ducts, ventilation

7