Removing And Installing The Control Motor Of Air Flow Flap V71 - Skoda Citigo 2012 Workshop Manual

– Unplug connector -1-.
WARNING
Danger of burn injuries.
Fresh air blower control unit - J126- may be hot.
Let the control system cool down before the removal.
– Release screw -2- (1 Nm).
– Remove the control unit -3- in -direction of arrow- from the
heating and air conditioning unit.
Install
Installation is carried out in the reverse order.
11.7 Removing and installing the control mo‐
tor of air flow flap - V71-
Removing
– Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
– Removing fresh air blower
– Carfeully release cable from the clips -4-.
– Unplug connector -2- from the control motor.
– Release screws -3- and -5-.
– Pull holder -1- with control motor as far forward as possible,
until the lever no longer engages in the control for control mo‐
tor.
– Push outside catch at the top of the holder -1- downwards
-arrows- and remove holder with control motor.
– Remove air flow flap control motor from the holder.
To this end press the catch pegs -arrows- outwards and si‐
multaneously remove air flow flap control motor out of the
catches -1-.
Install
Installation is carried out in the reverse order. Pay attention to the
following:
Note
The spare part dynamic pressure flap control motor - V71- is
♦
set to the end position "re-circulating air mode".
If necessary connect the control motor to the wiring loom and
♦
switch to position "re-circulating air operation".
– Press aif flow flap control motor into the holder.
– The following steps must occur simultaneously:
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
⇒ page 20 .
Heating, Air conditioning - Edition 06.2013
11. Climatronic - Air conditioner with automatic regulation)
97