Skoda Citigo 2012 Workshop Manual page 190

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
❑ fresh-air operation is automatically activated (no misting up of windscreen) if the "defrost function" is
switched on during re-circulating air operation; return to re-circulating air operation by again pressing the
re-circulating air button
7 - Dash panel temperature sensor - G56-
❑ with temperature sensor blower - V42-
❑ no longer fitted as of CW 46.2010
8 - Switch for air conditioning system - E30-
❑ The air conditioning system is only activated when the fresh-air blower is switched on
9 - Switch for fresh air and re-circulating air flap - E159-
10 - Potentiometer for temperature selector - G267-
❑ Control of interior temperature from 16 to 31 °C
❑ turning the rotary switch to the left or right up to the stop deactivates the temperature control (temperature
flap is fully open or fully closed)
❑ if the ambient temperature is higher than the set interior temperature, the air conditioning system must
be activated.
10.6.2 Plug connections on the Air conditioning
system control unit - J301-
Special tools and workshop equipment required
♦ Test box - V.A.G 1598/47-
Layout of the individual pins on the multi-pin plug connections A,
B and C on the rear side of the Air conditioning system control
unit - J301-
You can find the connection layout of individual pins in the con‐
nectors in the ⇒ Current flow diagrams, Electrical fault finding and
Fitting locations depending on the current model year and equip‐
ment.
10.6.3 Removing and fitting the heating and air
conditioning system control
– Take out the ignition key and switch off all electrical compo‐
nents.
Caution
When using the lever tool, mask points where the lever tool is
applied using commercially available adhesive tape.
80