Removing And Installing Fresh Air Blower V2 - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
– Remove flex shaft -1- from the control unit -3-
– Release catch -2- by pressing in the
-direction of the arrow A-.
– Swivel out control unit -3- in the -direction of the arrow B- and
remove from brackets -4-.
Install
Note
Before installing, check whether the position of the worm
♦
wheel -1- and the gear segment -2- correspond.
The higher turn (darker) -arrow A- must engage in the deeper
♦
gear openings -arrow B-.
– Mark the positions -2- and -5- of the lever of the temperature
flap -4- in the end positions (flap fully open/flap fully closed)
on the housing.
– Switch control unit -1- to position "flap closed".
– Close temperature flap.
Position lever -4- down to stop.
– Insert the control unit -1- in the brackets -6- and guide into the
housing in the -direction of the arrow-.
Control unit bolt -1- must engage in the slide -4-.
– press the control unit into the catch -3-.
– Insert flex shaft into the control unit -1-
– Check operation of the control unit.
It must be possible to adjust the temperature flap to its end
position in a smooth and easy way (markings -2- and -5-).
If the temperature flap adjustment is N.O.K.:
– Remove control unit again and install - as described above.
If the temperature flap adjustment is O.K.:
– Install flex shaft of the positioning unit.
– Install left footwell vent.
– Install the dash panel ⇒ Body Work; Rep. gr. 70 .
– Install the centre console ⇒ Body Work; Rep. gr. 68 .
4.6 Removing and installing fresh air blower
- V2-
Removing
– Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
20
Rep. gr.80 - Heating
⇒ page 12 .
⇒ page 12 .