Skoda Citigo 2012 Workshop Manual page 193

♦ Measuring tool set , e.g. -V.A.G 1594 C-
Removing
– Remove the centre console ⇒ Body Work; Rep. gr. 68 .
– Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
– Remove left footwell vent.
– Release screws -3- (5 Nm) and screw -1- (20 Nm).
– Slightly lever off the support -2- -arrow- and fix it by wedging
(e.g. wooden wedge).
– Unplug connector -1-.
– Carefully detach the wiring harness -3- from the cable straps
at the control motor of the temperature flap.
– Press catch -4- slightly forwards, swivel holder with control
motor -2- in -the direction of the arrow - and slide out of the
front holders towards you.
– Carefully pull the holder with the control motor through the
opening between the support and the heating and air condi‐
tioning unit downwards.
– Remove control motor from the holder.
To this end press the catch pegs -arrows- outwards while
pushing the control motor out of the catches.
Install
Note
The spare part control motor of the temperature flaps is on posi‐
tion "temperature flap closed".
– Press control motor into the holder.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
10. Climatic, air conditioning system with manual control
83