Removing And Installing Ambient Temperature Sensor G17 - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
– Open perforation of the cap -1- at the bottom of the heat-pro‐
tection matting -4- and fold up cap.
To guarantee the perfect operation of the valve for condensation
water drain, check the following:
♦ The valve for condensation water drain -5- must not stick.
♦ Sealing lip -3- of the gasket in the front wall (assembly plate)
must fit all round in the holder slot -2- -arrows-.
The valve for condensation water drain is positioned in the
holder -2- and on the heating and air conditioning unit.
♦ The heat-protection matting must neither be deformed nor
damaged around the valve for condensation water drain.
Note
When closed the cover -1- must be flush with the heat-protection
matting -4-. If the cover -1- is pressed too far inwards, the cap of
the valve for condensation water drain -5- may become stuck.
5.8 removing and installing ambient temper‐
ature sensor - G17-
It is located underneath the lower grid on the front left bumper.
Removing
– Vehicles up to MY 2010 - unclip cover(s) below for left fog light
from the front bumper.
– Vehicles as of MY 2011 (excluding RS and Scout) - place hand
through the grid in the bumper next to the left fog light.
– Vehicles from MY 2011 - remove front RS and Scout bumper
⇒ Body Work; Rep. gr. 63 .
– Unclip sensor -1- from the holder and remove -arrows-.
Install
Installation is carried out in the reverse order.
48