Removing And Installing Control Motor Of Fresh Air Flap And Re-Circulating Air Flap V154; Removing And Installing The Control Motor Of Temperature Flap V68 - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
– Press plastic part of the flex shaft -2- in
-the direction of arrow- and pull out of the heater control -1-.
– Use a flat screwdriver to press in plastic lug -arrow- of posi‐
tioning unit of air distribution flaps -2- and pull out flex shaft
-1-.
Install
Note
The flex shaft can only be installed in one way on the posi‐
♦
tioning unit and on the heater control.
When installing, however, the positioning unit and the rotary
♦
knob of the heater control must be in a certain position rela‐
tively to each other, otherwise this will result in malfunctions.
– Fit flex shaft onto positioning unit of air distribution flaps and
lock in place.
– Use the flex shaft to move the defrost flap into vertical position
("open").
– Set air distribution knob on heater control to "Defrost function".
– In this position, insert flex shaft into control and lock in place.
10.8 Removing and installing control motor of
fresh air flap and re-circulating air flap -
V154-
The work instruction for the removal and installation of the fresh
air flap and re-circulating air flap control motor - V154- is the same
as that for the heating unit
Note
If the control motor was replaced, perform a basic setting ⇒ Ve‐
hicle diagnostic tester.
10.9 Removing and installing the control mo‐
tor of temperature flap - V68-
Note
On vehicles as of CW 46.2010, the temperature flap is mechani‐
cally operated via the flex shaft, see
Special tools and workshop equipment required
82
⇒ page 15 .
⇒ page 19 .