Skoda Citigo 2012 Workshop Manual page 201

10 - Air flow flap control motor - V71-
❑ clipped into the bracket
❑ removing and installing
11 - Support
❑ for fresh air flap and re-circulating air flap control motor - V154-
12 - Fresh air blower - V2-
❑ removal and installation are identical with procedure for vehicles with heater units
13 - Holder for fresh air blower - V2-
❑ removal and installation are identical with procedure for vehicles with heater units
14 - Evaporator housing - bottom part
❑ Top part - bottom part connection with screws and retaining clips
15 - Filter cover
16 - Bottom part of distributor housing
17 - Heating element for air auxiliary heating - Z35-
❑ removal and installation are identical with procedure for vehicles with heater units
18 - Heat exchanger
❑ removal and installation are identical with procedure for vehicles with heater units
19 - Holder for control motor
20 - Control motor of centre flap - V70-
❑ removing and installing
21 - Seal for evaporator
❑ check fitting position: Water drain openings must point downwards
❑ as of 01.07, replaced by tape made of PUR foam, which is stuck onto the circumference of the evaporator
22 - Evaporator
❑ removing and installing
23 - Air distributor housing, top part
❑ Connection with air distributor housing, bottom part with retaining clips
24 - Support
❑ inseparable component of the central pipe, screwed connection to heating and air conditioning unit and
centre console support
❑ Tightening torque of heating and air conditioning unit: 5 Nm
❑ Centre console support tightening torque: 10 Nm
25 - Holder for control motors
26 - Defroster flap control motor - V107-
❑ removing and installing
27 - Control motor for temperature flap - V68-
❑ removing and installing
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
⇒ page 97
⇒ page 98
⇒ page 77
⇒ page 99
⇒ page 99
Heating, Air conditioning - Edition 06.2013
⇒ page 92
11. Climatronic - Air conditioner with automatic regulation)
⇒ page 20
⇒ page 20
⇒ page 14
⇒ page 14
91