Skoda Citigo 2012 Workshop Manual page 184

Hide thumbs Also See for Citigo 2012:
Table of Contents

Advertisement

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
❑ removal and installation are identical with procedure for vehicles with heater units
12 - Heat exchanger
❑ Summary of components
❑ removal and installation are identical with procedure for vehicles with heater units
13 - Positioning unit for temperature flap
❑ up to CW 45.2010 (India - up to CW 33.2010) - temperature flap control motor - V68- (flap actuated via
control motor)
with installed potentiometer for temperature flap control motor - G92-
Removing and installing control motor
❑ as of CW 46.2010 (India - from CW 33.2010) temperature flap actuated mechanically via flex shaft
removal and installation of the temperature flap control unit are identical with procedure for vehicles with
heater units
⇒ page 19
removal and installation of the flex shaft are identical with procedure for vehicles with heater units
⇒ page 12
14 - Gasket with holder
❑ clipped at heater unit
❑ replace if damaged
15 - Valve for condensation water drain
❑ behind heat-protection matting of the front wall (assembly plate)
❑ Fit only on removed heating and air conditioning unit
❑ check
⇒ page 47
16 - Plug for evaporator vent temperature sender - G263-
❑ on right-hand drive vehicles, positioned on the right
17 - Middle vent temperature sender - G191-
❑ no longer in use on vehicles manufactured from CW 46.2010 (India - from CW 32.2010)
❑ installed in the intermediate piece for dash panel vents
❑ to disassemble, remove damping trim panel below the left dash panel and footwell vent on the driver's
side, turn sender 90° to the left, take out, lower and release plug
❑ check ⇒ Vehicle diagnostic tester
18 - Evaporator vent temperature sender - G263-
❑ to disassemble, remove dash panel, release plug and pull out sideways
❑ on right-hand drive vehicles, positioned on the right
❑ check ⇒ Vehicle diagnostic tester
19 - Sealing ring
❑ replace if damaged
20 - Supports
❑ for cooling the storage tray in the glove compartment
❑ screwed onto housing
❑ no longer in use as of MY 2011
21 - Connecting hose
❑ to the storage tray in the glove compartment
❑ no longer in use as of MY 2011
74
⇒ page 6
⇒ page 82
⇒ page 14
⇒ page 14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents