Stihl MS 192 T Manual page 72

: Carefully drive the valve out of
the tank wall into the tank with a
drift dia. 6 mm.
: Remove the old valve from the oil
tank.
Ensure that the parts are installed
correctly.
: Carefully fit the valve in the hole
in the engine housing.
MS 192 T
: Carefully drive the valve out into
the hole in the engine housing
with a drift dia. 6 mm, working
from the outside.
: Fit a new valve in the hole
a = approx. 8...10 mm.
– Reassemble remaining parts in
reverse order.
13.5 Oil Tank Filler Cap
: Lift up the safety latch and
unscrew the tank filler cap (1).
: Prise the nipple out from inside
the tank (arrow).
1 2
: Examine the filler cap (1), cord
and sealing ring (2) and replace if
necessary.
The filler cap is supplied complete
with cord and sealing ring.
1
71