Stihl MS 192 T Manual page 24

1
Wet the inlay (1) with Loctite before
fitting it, b 16
: Press the inlay (1) as far as
possible into the opening in the
cover.
1
: Place the leaf spring (1) in the
opening (arrow).
– Lightly grease both the leaf
spring and the pin of the inlay.
The anchor pin must be replaced if
the groove in the brake spring
anchor pin is worn. Proceed as
follows:
MS 192 T
: Pull the pin (1) out of the cover
with a suitable tool.
– Wet the knurled area of the new
pin (1) with Loctite before fitting it,
b 16
: Position the new pin (1) in the
bore so that the knurling on the
pin meshes with the existing
knurling in the bore. Turn the pin
back and forth as necessary.
1
1
a
: Carefully drive the pin (1) home,
tapping lightly, until value "a"
approx. 4.3...4.7 mm is reached.
The pin must be driven in squarely.
1
1
: Prise off the bumper strip (1) with
a suitable tool.
– Check the bumper strip and
replace it if necessary.
– Reassemble parts in reverse
order.
: Slide the lever (1) through the
opening in the cover.
1
23