Stihl MS 192 T Manual page 50

1
3
: Fit the switch shaft (1), pushing
the rear contact spring (3) slightly
to the side.
Check operation:
The contact springs are fitted in the
handle housing at different depths.
This means that the rear contact
spring (3) and the front contact
spring (2) must make contact with
the metal pin of the switch shaft
when the switch shaft (1) is in
position "0".
– Reassemble parts in reverse
order.
– Set the air gap between ignition
coil and flywheel
b 9.1.1
– Reassemble remaining parts in
reverse order.
– Tightening torques, b 3.5
MS 192 T
2
49