Stihl MS 192 T Manual page 21

: Fit the clutch on the crankshaft
stub so that the raised hexagon
(arrow) is visible.
1
: Screw the clutch (1) with
hexagon (arrow) onto the
crankshaft stub and tighten it
down.
: Tightening torques, b 3.5
– Pull the locking strip out of the
cylinder.
– Reassemble remaining parts in
reverse order.
20
6.1 Sprocket / Clutch Drum
1
– Remove the clutch, b 6
: Draw the sprocket (1) off the
crankshaft stub.
1
: Remove the needle cage (1) from
the sprocket.
– Clean the needle cage and
crankshaft stub with standard
solvent-based degreasant not
containing any chlorinated or
halogenated hydrocarbons.
!
80%
– Examine the sprocket (1) for
signs of wear.
If there are distinct signs of wear on
the inside diameter of the sprocket
(1), the remaining thickness must
be measured. The sprocket must be
replaced if less than 80% of the
original thickness remain.
– Reassemble parts in reverse
order.
1
– Grease the needle cage and
crankshaft stub, b 16
: Slip the needle cage (1) onto the
crankshaft stub.
1
100%
MS 192 T